Recent content by Buck

Sure, $325 shipped USA only.

The Anafi is in excellent condition & has 11 cycles on the battery.

I purchased this and have had good results.

I just do it in the Anafi.

I typically use 32 or 64G Sandisk, but here is a official list. Subject of SD cards has be covered here.

How many people in the Anafi forums do you think are going to purchase the Anafi AI and are you planning on purchasing one? Given how Parrot has supported the Anafi this past year, I suspect the percentage is low.

Works fine on Android 7.

Stupid question; are you doing this inside your home?

You can get the FF6 apk's here.

None of his videos indicate his charging method, but show a Anafi battery housing, (lower & upper). Sides and rear cut away, leaving the USB C charger mounted in the upper section as normal and the BMS attached to the lower/front section as normal. Maybe he'll have the answers your looking for.

No the center tap was/is always connected using any charging method that includes balancing. This is accomplished by the BMS when using USB C charging or when charged using the after-market connection to the X6. (Ref-017 & 018) When a battery is fully charged by any method @ 8.7V it doesn't...

Ref-013 & 014 are visual aids. Also Ref-015 which is the original 2 cell Anafi 2700mAH battery.

Continued from post #115 (you may want to read comments up to this post.) Some additional testing of the Anafi 2S2P 3100mAH Tattu battery pack. BMS = Battery Management System. ~ (Tilde) = about or approximately. Previous tests indicated that the BMS was auto-landing @ 1% and the voltage was...

As I stated, sometimes my thoughts don't read very well. The BMS circuit is a mystery, but auto-land can be initiated by the mAH consumed or critical voltage. In air shut down appears to be caused when a cell reaches critical voltage, (3.1-3.2V) as detected by the BMS. The BMS does look at...

Though English is my native language, I am not the most proficient in explaining my thoughts. The original post was made to encourage people to come to their own conclusions. I have done more testing and hopefully later today will post my results with a clear explanation of the data. Your...