Recent content by HighViews

Thanks for the reply. So the low volts across the terminals proves that it is a faulty battery in your view. (Added later) I just noticed you are a staff member so it is time to recycle the bad battery.

I have two batteries. One works, the other doesn't. I just found out yesterday about the one that didn't work. I plugged it into the anafi with three green lights and the fourth plunking from when it was charging two hours before, and had no response when I pushed the on bitten. Latter at...

I reduced lag and bugs by going to settings, camera, Display Overexposure changing the default YES to NO. It made a huge difference for my slow phone to operate the drone properly. My theory is that the Overexposure Display took so many phone resources that the display appeared as connection...

Mine is making noise now too. The problem started with a blade of grass in it; pulled it out quickly and it worked fine. About a month later it ran slow and changed rpms. I took the bottom off and found a piece of debris (leaf fragment), thought I had it. The drone starts intermittently...

Has anyone noticed RTH behaving differently depending upon what Piloting Mode you are in? This morning I took off from point A in "Manual flight." Changed "Piloting Mode" while in flight to Cameraman, Follow Me, SmartDronies, then "Touch & Fly." When I was in "Touch & Fly" I chose a...

When you connect your Galaxy S8 look carefully through your notifications for "USB options" and make sure you select "file transfer." On my Galaxy J6+ a pop up appears after I do this and asks if I want to open FF6 with this USB connection. I check the box "Don't show this again' and OK...

I got my first Anafi in Nov. of 2018. My controller had the same issue before the end of the year. Maybe four or five weeks. I had flown it 10 or 15 times. Maybe the fact that I left the USB-A plugged in between flights sometimes made things worse. Parrot support back then, after a week of...

You can use Touch & Fly (make sure you have prepared your map for the area), change TYPE to POI, change to map view after take off, i think you long press on the POI on the mab, adjust the height, make sure you are high enough to clear any obstacles then fly right or left manually, The camera...

1st experience: Samsung Galaxy J6 Plus works so far no issues. In follow me dynamic, while walking straight, the Anafi drifts right and left probably due to the compass in my device getting jarred a little as I walk. 2nd experience: About May 2019 my phone updated to Android 9. Now there is...

It fixed the camera not tilting in Flight Plans with no poi identified. See this video This is a test of Flight Plan in Free Flight 6 v6.4.1. You will see that the Anafi camera will tilt without a poi in a flight plan, but the Anafi still pauses between waypoints. At each waypoint there is...

Your comment is very well put. Thank you for it. Have you gotten the camera angle to adjust with no poi used since the FF6 v6.4 update?

Thanks, but it looks like he had success because he didn't have a poi for his way points where he adjusted the tilt. I know the video was just published, but I don't know if he was using an android device, nor do I know if the flight plan was performed prior to FF6 v 6.4 update. Flight plan...

This new updated added one problem to flight plan that worked properly before. The camera doesn't adjust at all in flight plan if there is no poi chosen. So if the camera is at 0 deg. at 10' the next way point is say 200' back and 120' high and you place an angle adjust before the 120' way...

I had a USB-A connection issue with my SC3. I had over 10 successful flights with the SC3. The trouble started for no apparent reason about 4:30 PM 12/27/18 when the SC3 failed to connect to my phone with two diffrent USB cables so I flew a flight-plan flight with my phone only. Since then I...

Just tested increasing the Film mode Max inclination, and it did not increase the orbit speed. After asked, I thought it probably wouldn't work, but I still did the test.