Recent content by MightFlight

Lots of variables. The mavic 3T has a better resolution than Anafi USA 4K60 and 640p thermal and way better flight time. Are the internal components better than USA"s? Probably not. Is the mavics thermal and tele cameras higher quality than USA's? Probably not. Is the control and video link...

Antenna cord attached to leg

I had this message, but was not a motor problem. Had a motor stage error on the bebop 1 and the antenna wire was broke. Put in a new antenna in the back foot and that message went away. It must detect it somehow through software.

No motor upgrades since they are brushed motors. Like the Bebops you can use any gaming controller with bluetooth, because you are not actually going from controller to drone, but controller to app to drone.

My interference graph in settings still doesnt show from time to time. Did you do any work on it? Also you should mod the wifi channel switch like anafi usa does in mid air to be able to change channels in air without having to land first.

FInd a way to secure it with wpa2, but until then it is vulnerable.

FF6_6_7_6_FCC_SE_BATTERY.apk Good so far - a few problems, may be props or app but vibration warnings on hand launch and take off from ground. Also the interference graph on the wifi channels is missing sometimes. I wait for it to show but certain times it never does.

It is very true.

Yes, that was the post I originally intended to reply to. If you say you have multiple devices paired maybe this is isolated to 1 FF6 device setting on mine, but I can assure I have checked EVERYTHING on it. I dont think parrot made 2 different sc3 versions for power as well if it is steming...

OK so None of the above steps worked for me. I cant pinpoint if the issue is FF6/device compatibility problem with using more than 1 drone on a single device or vice versa or that it is just a device specific issue. It will refuse fcc on one but allow it on another using the same parrot...

Thanks for the response and digging up that info. It is an android with OEM FF6. I'll give the suggestions a go and reply back

How

In some way, some how in the course of almist 12 months while I have been flying the anafi fpv version it has some how reverted back to CE mode. Any attemps such as the previous successful drone UI reset that reverted it back to FCC does not work anymore. This just happened by itself all of a...

Yes

Maybe its a defect. When the drone is closed all touch when open only 3 touch. Maybe the plastic spacer ring is in wrong? No motor wires look caught at the hinge.