Recent content by orybarfly

Hi all, Does anyone know a way to revive a bricked parrot anafi? Is there a firmware image available for the Anafi that could be loaded into the drone via, for example, the SD card? Is there any other way?

Try to do that with your mobile data on because the wifi is taken by the Anafi and you don't have access to the internet for synchronization

It started after a certain version number and was never corrected. It has nothing to do with the propellers, it mainly deals with the horizontal stabilization, they messed up the stability of the POI at the same time. I hope they will deal with it, but it is highly unlikely.

So far I have been installing the modded app versions directly over the previous modded versions. The fcc channels where showing directly, without any effort, except for the last time with the 1.7.4 version Στάλθηκε από το MI 5s Plus μου χρησιμοποιώντας Tapatalk

What version have you installed and still have the fcc channels? Στάλθηκε από το MI 5s Plus μου χρησιμοποιώντας Tapatalk

Yes Στάλθηκε από το MI 5s Plus μου χρησιμοποιώντας Tapatalk

I just installed the new version over the previous modded 6.7.3 but lost the fcc channels since then The se means that I can select whether fcc is enabled or not? How could I switch it on again? Στάλθηκε από το MI 5s Plus μου χρησιμοποιώντας Tapatalk

Look for Tamara Leitch at fb Στάλθηκε από το MI 5s Plus μου χρησιμοποιώντας Tapatalk

I am using "Touch & fly" POI a lot when I am shooting videos. After the last 2 updates (1.7.6 and 1.7.7), there is a lot of instability in the video, the camera seems to move gently left or right instead of being rock solid focused on the POI. I have 2 Anafis and they both do the same, so it is...

Try hand launching. Press take off but don't throw it in the air until you are satisfied with the engines rotation Στάλθηκε από το MI 5s Plus μου χρησιμοποιώντας Tapatalk

I wish it was that easy. You cannot downgrade your drone's firmware. In any case, I don't have any version of the drone's firmware.and, to my knowledge, it is downloaded through the freeflight app. Once you upgrade, there is no turning back.

Anafi with firmware 1.5.6 is the latest firmware version to maintain high output power on the drone side, that can provide solid connection up to the advertised 4km (according to solaris). On every other version after that, solaris has measured a reduced transimision power from the drone side...

The new Anafi version 1.7.6 has problems with the horizontal stabilization. It can ruin your videos because it happens anexpectedly and without any side winds. @ds2atc is it possible for you to make a FCC modification for Freeflight V6.1.1? I have an Anafi firmware 1.5.6 that can still transmit...

Try to use "touch & fly", Point of interest (POI). The drone will always face the subject (must be stationary) and you can use the sticks to fly however you want. You can even do smart dronies, like dolly zoom on it Στάλθηκε από το MI 5s Plus μου χρησιμοποιώντας Tapatalk

All the drones that display or monitor their altitude are using an internal barometric sensor. They keep a record of the barometric pressure at take-off to mark their zero point altitude and, based on the change in the pressure, they compute the altitude. No maps or GPS or 3g are needed to...