Recent content by Waldo Pepper

Yes, I remember getting great range with Anafi. Then, Updates can't recall which one it started with range was terrible from there. Still, Anafi was a great flyer and fun. I won't get another one, gimbal issues eventually took over with each of the three Anafi's I had.

Good morning Gravityzero, Replied to your pm, most definitely a Bebop 1 camera will work with a Bebop 2. Keep us posted, hopefully all works out well and you get the Bebop 2 back up in the air. Good luck! Paul

Looks like the previous owner added an outside booster setup or used different set of antennas. If you can’t get the antennas needed to mount on these connections, open up the controller and re-fasten the original antennas connectors. If you need additional information, questions please...

PM your mailing address, And description of battery. Is it the thin cylinder type battery or square type battery. This is important, two different types batteries were used with SkyController 2. As Mike explained two different types of batteries were used. I’ll send you the proper battery...

Hello Bryan, As Mike added, yes you can use a different color prop as long as non-holed or holed propeller are on proper motor. These are all questions and experiences we experienced ourselves when we first purchased the Bebob, Don't hesitate to ask questions please continue to ask. We’ve...

If memory serves me right, When flying an obstacle course with Bebop 2 operated in Roll Stabilization mode. Increased some settings and unfortunately forgot most of the settings, I’ll need to try this out again, my course was in thick foliage with a lot of large California oak trees with...

One thing I need to mention, you don’t want to go any higher on voltage with SC2P, it’ll fry the controller.

i would think Li-ion section would be the proper charge method, battery does show it’s a Li-ion battery. Hopefully, others will chime in several here on this forum are very knowledgeable with electronics. I too use the SkyController 2P, but went with a Lipo batteries and LiPo charger. Someone...

Wow! So cool, was fun seeing Parrot Bebop 2 racing. See at least one famous movie star, very fun.

Impressive, extremely we’ll built. Congrats!

Looks like each leg detaches with thumb screw, legs fold over for storage. Still, it does break down for storage into a smaller bag. I like it.

Just checked, still on 4.71 app, I’ll continue to use this firmware. Paul

I haven’t flow a Bebop 2 in about 5-6 months, have six of them 5 are modified. Can’t remember what the latest firmware is, I’ll fly a couple this weekend get reacquainted with them. I stopped using the Auriga app, can remember why. Strictly stay with Freeflight now, looking forward to flying...

Hello, Everything looks good, except for C1703 component, looks like a piece of solder spilled onto this component, or a scratch? This may be part of the problem? if it’s solder, cut off at the point it’s soldered on. Hopefully, everything is alright. Removing the USB cable will disconnect...

You’re welcome Gonzalo We’ve been in your shoes before, with first time installing the bebop 2 booster kit. We understand, we’ve been there ourselves. You’ll eventually understand the installation, enjoy the learning process. I never added the resistor to the positive wire soldered...