ALIENTECH Bracket

sprill22 · Jul 4, 2019

Hmm, an ALIENTECH extender bracket. Could this help with 'interference'? I guess one attaches a pair of ariels.

US $46.91 6% OFF|ALIENTECH Bracket With Cables For PARROT ANAFI Remote Control (RC) PARROT ANAFI drone BY ALIENTECH DESIGN-in Drone Accessories Kits from Consumer Electronics on Aliexpress.com | Alibaba Group

Jagerbomb52 · Jul 4, 2019

Yes the bracket allows you to use after market antennas. I like the bracket for the way it attaches to the controller allowing you to put the controller back to stock if you need to for warranty. I don't like the antenna connectors being snap on. Not many after market antennas with this feature. Most just screw on.

sprill22 · Jul 4, 2019

Ah yes thanks, not ariels.

Waldo Pepper · Jul 4, 2019

I almost ordered that bracket, nicely made.

Like Agustine, don’t care for the snap connectors. They eventually have poor connection and signal will be lost momentarily creating disconnect, threaded connectors are best.

Paul

sprill22 · Jul 5, 2019

Would it be possible to use these do you think?

US $0.7 22% OFF|Extension Cord U.FL IPX to RP SMA Female Connector Antenna RF Pigtail Cable Jumper for PCI WiFi Card RP SMA Jack to IPX RG178-in Connectors from Lights & Lighting on Aliexpress.com | Alibaba Group

Waldo Pepper · Jul 5, 2019

sprill22 said:
Would it be possible to use these do you think?

US $0.7 22% OFF|Extension Cord U.FL IPX to RP SMA Female Connector Antenna RF Pigtail Cable Jumper for PCI WiFi Card RP SMA Jack to IPX RG178-in Connectors from Lights & Lighting on Aliexpress.com | Alibaba Group

That looks like they should work, good luck!

Nidge · Jul 5, 2019

With regards to the connectors, those are bnc RF connectors with an upper frequency limit of close to 4GHz. This would mean that if you use 5.8GHz for the benefits of a larger bandwidth and greater fidelity in the downlink you would also experience a significant loss/attenuation in the link between the controller and the drone.

Regards

Nidge.