Anafi LED connector - how to replace?

[DroningSermon]

I was able to replace a broken leg yesterday using the great info on this forum.

But I managed to damage the LED light connector (see pic). The drone seems to work fine without it, but I would like to fix it obviously. Any idea what the connector is and where I can obtain it in the US? I can do some soldering / crimping.

 

[70Falcon]

I did the same thing with one of mine. I didn't know that the connector lifted off rather than slid out of the base, and my base is broken on one side. The wired connector is still intact. I can tell you which wire goes where, but I have no idea of the connector base model, or where to get one...

 

[DroningSermon]

I did the same thing with one of mine. I didn't know that the connector lifted off rather than slid out of the base, and my base is broken on one side.

Same here, I tried to pull it out instead of lifting it out.

 

[70Falcon]

Same here, I tried to pull it out instead of lifting it out.

The motor connectors lift off as well. I don't remember any that pull out.

Let me know if you need the wire locations...

 

[DroningSermon]

Thanks, there is a good repair post here that has a picture with the wire colors and locations. So I just need to find the connector now. For the moment, I taped off the three wires, and the drone seems to work without complaint.