[USER=970]@FrancoisTX[/USER] Thanks so much! This eventually worked! I had to do it twice for some reason, I suspect I released my finger too early when the drone was resetting as only a couple of sections of red came up on the battery initially.
I am able to connect the drone directly via the USB-C to USB-3.0 cable that shipped with the Anafi & also with using a USB-2.0 extension, so it doesn't have to be so close to the iMac.
Thanks again, I was just starting to look at buying an expensive USB-C to USB-3.0 adapter!
*** Update ***
Last night for some strange reason the iMac wouldn't recognise the Micro SD card again! After another hard reset of the drone by holding the power button until all four lights went red, then restarting the drone & plugging it in again it worked.
This morning, it was recognised immediately & the transfers are happening as I type this, as can be seen in the image below! Thanks again [USER=970]@FrancoisTX[/USER] !
[ATTACH=full]782[/ATTACH]
