Good day all,
I'm new here, this is my first post.
I took the Anafi out today and it crashed on the first flight. Right before the drone took off, the software updated the firmware in the drone.
The drone was about 10 meters high, 50 steps away - in manual mode - and it fell like a stone. I can't see any reason, there was no obstacle and no strong wind.
The software hasn't recorded the data for that flight, which lasted about 30 seconds. The battery was fully charged.
Well now I can't turn it on. There's no visible damage on the body - but when I press the switch, the LEDs are showing that battery is fully charged and that's all. The LEDs go off and the drone shuts down.
Would anyone know here how I could bring the drone back to life?
Cheers,
Nick
I'm new here, this is my first post.
I took the Anafi out today and it crashed on the first flight. Right before the drone took off, the software updated the firmware in the drone.
The drone was about 10 meters high, 50 steps away - in manual mode - and it fell like a stone. I can't see any reason, there was no obstacle and no strong wind.
The software hasn't recorded the data for that flight, which lasted about 30 seconds. The battery was fully charged.
Well now I can't turn it on. There's no visible damage on the body - but when I press the switch, the LEDs are showing that battery is fully charged and that's all. The LEDs go off and the drone shuts down.
Would anyone know here how I could bring the drone back to life?
Cheers,
Nick