Does anafi have any way of performing this function? In most drones it is possible to put the engines in a 'warm up' rotation, pulling the stickers down and out. It gives the pilot some security, do this before the flight.
Bypassing the problem: configure the flight to start, 'by hand', then do not throw it into the air.There is no way that I know to slowly run the motors without taking off. The Anafi just "gets up and goes".
What is the point of this? A cold engine works just as well as a warm one (in fact, better).Does anafi have any way of performing this function? In most drones it is possible to put the engines in a 'warm up' rotation, pulling the stickers down and out. It gives the pilot some security, do this before the flight.
What is the point of this? A cold engine works just as well as a warm one (in fact, better).Does anafi have any way of performing this function? In most drones it is possible to put the engines in a 'warm up' rotation, pulling the stickers down and out. It gives the pilot some security, do this before the flight.
The expression 'warm up' used at the beginning of this article is figurative so it is in quotes. The important thing, that the anafi does not have in a direct mode, is to check in a safe place (on land), if the engines and helices work correctly. OK ?I would be happy if all brushless motors would stay cold. This is a good sign. Warm motors indicate an issue. (We are not talking here about frozen parts ;-) )
As @Gipsz Jakab said: the battery should be warm, at best have an internal temperature of 38°C.
The quotation mark was in the wrong place. The warm-up shouldn't have been quoted, because it's really a warm-up ... it's just not the engines that need to be warmed up. OK?The expression 'warm up' used at the beginning of this article is figurative so it is in quotes. The important thing, that the anafi does not have in a direct mode, is to check in a safe place (on land), if the engines and helices work correctly. OK ?
If you say !!!,,, then remove the quotation marks and read as you wish, I keep everything I said and this is how I proceed and will proceed.The quotation mark was in the wrong place. The warm-up shouldn't have been quoted, because it's really a warm-up ... it's just not the engines that need to be warmed up. OK?
I don’t want to argue, I prefer to think: If you have turned on handlaunch, you can lift and hold it in your hand and activate hand launch. The rotors will then start and rotate at a low speed, hold the drone until it warms up. Then throw it in the air and fly.If you say !!!,,, then remove the quotation marks and read as you wish, I keep everything I said and this is how I proceed and will proceed.
I don’t want to argue, I prefer to think: If you have turned on handlaunch, you can lift and hold it in your hand and activate hand launch. The rotors will then start and rotate at a low speed, hold the drone until it warms up. Then throw it in t