Hi all!
Couple of weeks ago I crashed my anafi from just a couple of meters high. Gimbal was bend which caused an error during startup because it got stuck during calibration. I managed to fix this by sanding of a bit if the camera housing.
Drone is flying again but seems very unstable and the buzzing seems much louder then before. Especially when descending. The crash was on his gimbal and right front motor (on the beach, so relatively soft crash). The axis of the motor seems to have a very very small movement which I do not find in the other motors. Can this be the cause? Does anybody have tips to check what can cause the noise?
I did not replace the props because the all look fine.
Thx!
Couple of weeks ago I crashed my anafi from just a couple of meters high. Gimbal was bend which caused an error during startup because it got stuck during calibration. I managed to fix this by sanding of a bit if the camera housing.
Drone is flying again but seems very unstable and the buzzing seems much louder then before. Especially when descending. The crash was on his gimbal and right front motor (on the beach, so relatively soft crash). The axis of the motor seems to have a very very small movement which I do not find in the other motors. Can this be the cause? Does anybody have tips to check what can cause the noise?
I did not replace the props because the all look fine.
Thx!