BRC
Well-known member
Have you tried to take off Anafi in manual flight mode first and then initiate flight plan while it is in the air hovering?Indeed, special while Rodrigo has exact the same problem.
Have you tried to take off Anafi in manual flight mode first and then initiate flight plan while it is in the air hovering?Indeed, special while Rodrigo has exact the same problem.
Yes, + everything is possible, thank you. I ordered a new Anafi. The old one becomes my spare drone. I will use this without updates for the flight plan. (Flew 2,5 years and 300 flightplans without a problem) I still have to find out which APK app works well with the firmware version on the new drone (not yet 1.8 I think) and the flight plan. In our urban environment with a lot of vegetation, buildings and in CE mode, the signal is usually too low to fly the Anafi manually. Again, thank you very much.Have you tried to take off Anafi in manual flight mode first and then initiate flight plan while it is in the air hovering?
I did, and it flew 1 flightplan and then... hovering.Just Anafi hard reset done and tried again but no succeed stay hovering
what next? to get another android device install app ,try again
I have good results with hand landing under this update. I let it hover about 3 feet above my hand, then hit the landing button. I make a point of holding my hand very flat and steady.Something to report. Hand landing won't work for me anymore, drone motors keep spinning while landed on my hand they used to shut off last firmware.
I didn't turn anything off. I am using an application modified by Anafipilot1 (6.6.2 battery mod) and I simply do not click on the update button. It goes with the old 1.6.3 firmware without any problems.You are right. One more question: Is there a way to turn off automatic updates and upgrades when everything is working fine?
Thank you very much.I didn't turn anything off. I am using an application modified by Anafipilot1 (6.6.2 battery mod) and I simply do not click on the update button. It goes with the old 1.6.3 firmware without any problems.View attachment 5667
Updating test with Flight Plan issues
Yesterday I tried different old version till from 6.74 to 6.6.6 on android 9 none of them could connect the video image using the SC3 beside last version 6.74 and flight plan worked in some of them using Wifi to connect the device , no SC3 but all of them crashed leaving without control for a while the anafi until reconnected with SC3 to land
I have done what highanddry suggested beside to use a device with android 7, can not see any improvement
This is very weird I not sure if are more pilot having the same issue and also with landing as I showed in previous post, this happens yesterday all the time when landed ,absolute not normal like he reject to land, I have more video to show and will post soon and all is began since last updates
Issues when connect SC3 with oldest FF6 version , No camera image,
Understand but this is only if you connect the SC3 and not through the WiFi to the phone or tabletThat is because your drone is running firmware 1.8.0, the latest drone firmware will not work with older FF6.
If I do a manual landing, I go down MUCH slower near the ground than you do. Then landing is easy. Perhaps give it a try?
This. You need to use the FF6 version that was released with the firmware for SC3 and Anafi.If I do a manual landing, I go down MUCH slower near the ground than you do. Then landing is easy. Perhaps give it a try?
Also I would never use firmware (drone, SC3, battery) and software (FF6) versions that are not published together. Unpredictable things can happen if you e.g. use newest drone firmware together with old FF6.