Hi,
I am hoping someone here can help diagnose a problem that my Anafi is suffering from. A couple of months back it suffered a crash where it hit a tree branch and crashed to the ground from around 6-8 metres.
The rear left leg (M3) was split but the rest seemed, cosmetically, fine. Some of the props were damaged too.
It bobs up and down in the air without touching the controller when in little to no wind. Left and right it seems OK but it will constantly bob up and down without staying still. Is it the software that is constantly trying to correct itself against instability that is causing it?
Has anyone had anything similar happen and found a repair route? A video is here:
. There was no wind when this was captured and the controller is not being touched.
Steps I have taken to try to correct it:
1) had the M3 replaced
2) replaced visibly damaged props where they had notches in them
3) hard-reset the drone and calibrated controller, drone and gimbal
Possible things to try?
a) should I replace all props just in case the scuffed ones are having an affect?
b) can I turn off the software stabilisation to watch without auto-correction as this might help identify an issue with the legs or something?
c) how would I diagnose if the damage is more central like a gyro stability issue?
d) anything else?
Any help is greatly appreciated.
I am hoping someone here can help diagnose a problem that my Anafi is suffering from. A couple of months back it suffered a crash where it hit a tree branch and crashed to the ground from around 6-8 metres.
The rear left leg (M3) was split but the rest seemed, cosmetically, fine. Some of the props were damaged too.
It bobs up and down in the air without touching the controller when in little to no wind. Left and right it seems OK but it will constantly bob up and down without staying still. Is it the software that is constantly trying to correct itself against instability that is causing it?
Has anyone had anything similar happen and found a repair route? A video is here:
Steps I have taken to try to correct it:
1) had the M3 replaced
2) replaced visibly damaged props where they had notches in them
3) hard-reset the drone and calibrated controller, drone and gimbal
Possible things to try?
a) should I replace all props just in case the scuffed ones are having an affect?
b) can I turn off the software stabilisation to watch without auto-correction as this might help identify an issue with the legs or something?
c) how would I diagnose if the damage is more central like a gyro stability issue?
d) anything else?
Any help is greatly appreciated.