If you place a tilt setting in same timeline slot as takeoff (1st position) then drone will just hover after takeoff
Remove tilt setting in takeoff slot - save and then reload plan it will work
It's ok to have tilt settings in all the other slots
btw - after you make the correction you may need to initiate plan twice - only after a failed takeoff
i.e, start plan (takeoff) and if it just hovers land drone and the start plan again
Same happens when creating plans in FF6 or on esparus, think it started with FW1.8.0
Not sure how Rodrigo figured this out!
Check out this thread sounds like it could be the same issue you are running into -
has to do with tilt of camera on take off - post #66
yes I did , hard reset and re-calibration as well before this short video, also using all up to date Manually landing that is most of the time I do, but automatic [pressing the bottom ] or from flight mission could this happens .At the first time I thought maybe has to do with magnetic...
parrotpilots.com