hi everyone, i'm new to the group but i have been following you for a while, i also noticed that something has been changed, in fact i can't use the FCC mode, i attach photos of my configuration, i must say that it bothered me a lot realize that you can no longer use this mode, not for long range, but to have a more robust and reliable signal in particular conditions, however now it is a problem, you should make programmers understand that this is an important factor, FCC mode makes the safe and reliable signal especially in areas with a lot of wifi interference (which could create problems) ... in this configuration I violated for over 15 minutes (of course THERE IS MODE ... unfortunately) but ANAFI flew without problems ... I downgraded the app from 6.6.6 to 6.6.2 using fake GPS and installed everything without satellites. just turned on the TX and smartphone on the wifi signal I noticed that when I turned on the drone for a few seconds FCC MODE appeared, but only a few seconds, then automatically and returned to CE mode. I'm sorry to provide only this as information but I hope it will be useful ... at the end of my test I installed the latest version of the app (which however does not affect the firmware of the drone and the tx command) at moment I don't upgrade the firmware 1.6.7 but use only 1.6.5 how I show in photo... wait news...sorry I'm in Italy